2 pin power plug for the front of RackInjectors including the Power Distribution Unit Board. These are to replace lost or broken plugs. An appropriate number of these is already included with each device...

This is nominally a 24V 3A power supply (the exact rating may change depending on our sources) which can be used to power a PowerInjector for the Canopy 100 or 450 series radios. This power supply has been sized to power up...

4 pin power plug for PowerInjectors. These are to replace lost or broken plugs. An appropriate number of these is already included with each device.

This is a DIN rail or wall mountable current shunt for the SiteMonitor and other products which need a 100mV shunt. This shunt will produce an output voltage of 100mV at the output terminals when the current matching the...

DIN rail clip for Base Unit II and expansion modules. These are to replace lost or broken clips. One clip is already included with each device.

This is a non-controlled version of our 4 Port PoE injector. It permits injection of a voltage you supply (per port) onto a CAT5 cable for use by radios and other devices which use spare pair PoE - that is, expects power on...

 Key product features are as follows:   Designed to provide power and sync to radios which are compatible with the 56V CMM5. Provides the newer "Cambium Sync" style synchronization which can be used by the...

Dual Voltage Inputs and Jumper Settable PoE injection supports both Cambium and non-Cambium Radios.      Our PowerInjector plus Sync Product permits the powering of almost every different type of radio or...

This is a Control Board for the RackInjector. It is intended as a replacement in case one is damaged. It needs to be installed in the RackInjector case with all the cables connected in order to be functional. 10/100...

RACKINJECTOR FIRMWARE NOTE: We have a limited-release version of firmware for the RackInjector Control Board to support this product. Please email custsvc@packetflux.com if you need to install one of these boards in a...